MOOSE Z950 Manual de usuario descargar pdf (Pagina 7)

1.2 Arming

Arming The System Prior To Leaving

Before your security system can be armed, all of the intrusion zones

must be secure as indicated by the green READY indicator. If the

READY indicator is off, one or more zones are faulted. The

indicator(s) corresponding to the faulted zone(s) will light. Determine

the areas of protection which are assigned to each of the zones, then

check the appropriate doors and windows to see that they are closed.

1. Verify that the READY indicator is on.

2. Enter your User Code.

3. The keypad will begin beeping and the red ARMED indicator will blink

to indicate that arming will take place after the exit time expires. (The

ARMED indicator will light steady after the system arms).

4. Leave the building immediately.

The control is programmed with an exit delay time which allows a specific

amount of time to leave through any delay defined intrusion detection zone

without causing an alarm. Be sure that you have been informed on routes to

enter and exit from without causing an alarm.

On the Z950/Z880 only, the beeping tone will become more rapid for the last 10

seconds, warning you that arming is about to occur. If the exit door is not

secure during the last 10 seconds of the exit delay, then the exit delay will be

restarted for one full exit delay period. This exit delay restart is only performed

once.

User's Manual

1-3

1 2 3 4 5 6 7 8 9 10 11 12 ... 50 51

Sin comentarios

MOOSE Z950 Manual de usuario Pagina 7