MOOSE ZXSSD Guía de usuario Pagina 7

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 52
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 6
7
KEY #6 CHIME KEY
This key turns the chime function on or off for a particular area.
KEY #7 RST SMOKE KEY
This key resets all latched smoked detectors and clears “Smoke Troubles”.
KEY #8 TEST KEY
This key allows you to perform one of the six following tests: Walk, Battery, Bell, Communications,
Keypad, and RF Signal Strength. After a valid passcode is entered, you may select the test to perform.
KEY #9 PROGRAM KEY
This key is used to enter installer or user level programming. User level programming is described in the
appropriate User Guide. Installer level programming is described in Chapter 3.
KEY #0 ACCESS KEY
This key is used to activate a door strike or other similar function.
The installer passcode may be used to arm one or both areas. It may be used to disarm one or both areas, but only if the area
was armed by the installer passcode. It may be used to silence alarms and to silence trouble conditions. When it is used to
silence a Burglar alarm, it will not disarm the area or cancel the alarm unless the area was armed by the installer passcode.
For a detailed description of arming and disarming procedures, see the appropriate User Guide.
1.6 Installer Arming and Disarming
The Control Station secondary function keys may be activated by pressing the ENTER key followed by Key #1 through
Key #6. A passcode is not required to activate these functions. These functions are activated by pressing the following:
ENTER + KEY #1 Turns Lamp Trigger Output ON or OFF
ENTER + KEY #2 Turns Universal Output ON or OFF
ENTER + KEY #3 Quick Access from Keypad
ENTER + KEY #4 Turns Key 4 Output ON or OFF
ENTER + KEY #5 Turns Key 5 Output ON or OFF
ENTER + KEY #6 Turns Key 6 Output ON or OFF
Please see section 3.2.5 for more details on the operation of these functions. The above outputs are only available to the
user if you program them as Programmable Outputs. If any of these features are made available to the user, please instruct
the user on their operation as it is not detailed in the appropriate User Guide.
1.5 Secondary Function Keys
WWW.DIYALARMFORUM.COM
Vista de pagina 6
1 2 3 4 5 6 7 8 9 10 11 12 ... 51 52

Comentarios a estos manuales

Sin comentarios